Manual for FP3 Board
Pic8
After finished the calibration, then the software will be minimize it on task bar
, then you
can use the finger to touch the screen now.
Manual Calibration
If you cannot do auto calibration, then you can do manual calibration.
1, Please choose "Auto Mask Clutter" from "Mask Bitmap Edit" or you can press Ctrl+Shift+A. The
software will specify the active area automatically. The other area will be shielded by green mask.
2, Touch each corner and check if it can be seen from the calibration screen like below. If some corner is
not included, please eraser the green mask (Mask Bitmap Edit-Erase Mask Area).until you can see
the spot as below.
9