Table of Contents
Advertisement
Lighting the oven gas burner
The thermostat allows the automatic control of the temperature.
The gas delivery to the oven burner is controlled by a two way thermostatic tap (oven
and grill burners) with flame-failure device.
To light the oven burner operate as follow:
- Open the oven door and apply a lighted mach or taper to hole "A" in the oven base
plate (fig. 6)
- Push and turn the oven knob anti-clockwise to position 230.
- Once the oven burner is lit, wait for about 15 seconds before releasing the knob (time
of priming of the valve) and then close the oven door slowly.
Turn the oven knob to the position for the required temperature (see the thermostat
grade table).
Should the flame of the burner estinguish for any reason, the safety valve will cut
off automatically the gas flow to the tap. To re-start operation, take the knob to
"off" position and repeat operations as above explained.
Oven thermostat
The thermostatic control tap knob (fig. 5) is marked with numbers from 130 to 230,
these correspond to the oven temperature, in addition the "OFF" position is shown by
the symbol
.
To choose the required oven temperature (check with the "Oven cooking guide"), turn
the control knob until the number, required is level with the line mark on the control
panel (facia).
Fig. 5
How to use the gas oven
A
Fig. 6
7
Advertisement
Table of Contents
