Component Locations - Linear RE-1 Installation, Programming And Operation Instructions

3
2
1
9
8

COMPONENT LOCATIONS

1 KEYPAD
Die-cast metal 12-key keypad with tactile action. For system
programming and keying in entry codes.
2 DOWNLIGHT
Illuminates keypad and visitor operation buttons. The light can be
programmed to operate dusk to dawn and adjusts its time depending
on the system's geographic location.
3 OPTIONAL CCTV CAMERA
Location for the optional Model RE-BWC1 CCTV camera. The camera
views the keypad area and has infrared lighting for nighttime use.
4 MICROPHONE
The high-sensitivity microphone monitors sound at the keypad area
for the entry system's speakerphone.
5 CALL BUTTON
Pressing this button causes the system to call the residence
telephones with a distinctive ring signal.
6 HELP BUTTON
Pressing this button causes the system to play the help message to
instruct the visitor on system use.
7 SPEAKER
Weatherproof speaker for system operation and programming.
8 INTEGRAL ANTENNA
Hidden antenna receives wireless radio signals from transmitters.
9 OPTIONAL KEYLOCK
Location for mounting access keylock. (MEDECO keylock with
stainless steel cover shown).
10 MAIN TERMINAL BLOCK
For power, backup battery, sense inputs, open request inputs, and
remote keypad connections.
11 SPEAKERPHONE VOLUME CONTROL
Controls the audio level produced by the speaker during
communications between the visitor and the resident.
4
CALL
5
6
7
12 RELAY TERMINAL BLOCK
13 RELAY INDICATORS
14 ANTENNA TERMINAL BLOCK
15 LINE MONITOR JUMPER
16 DIGITAL SPEECH VOLUME CONTROL
17 STATUS INDICATORS
18 VIDEO CONNECTOR
19 CAMERA CONNECTOR
20 RESTART BUTTON
21 TELEPHONE TERMINAL BLOCK
13
12
11
10
21
For Relay #1 and Relay #2 output connections to the access control
devices.
Indicators for Relay #1 and Relay #2 will light when the relay is
activated.
For shield and center conductor connection of the coax cable from
the system's built-in radio antenna.
For testing and troubleshooting. Remove jumper to listen to
telephone line audio through the speaker.
Controls the audio level of the voice synthesizer. This adjustment
effects the audio level of the voice synthesizer and system tone from
the speaker.
Six indicators light to display system power, radio, and modem
status.
For cable connection to a video monitor. (Optional Model RE-BWC
CCTV camera required).
Provides power and video connection for the optional Model RE-
BWC CCTV camera.
Pressing this button restarts the system. This button DOES NOT
erase any programming data.
For telephone line and earth ground connections.
14
15
16
17
18
19
20
3