Table of Contents
Advertisement
Available languages
Available languages
Light Shield Installation
If your light does not come on at dusk or turns off un-
expectedly, then another light source may be activating
the daytime shutoff feature. Possible sources of light
interference are street lights, landscape lighting, other
security lights or lanterns, or an interior house light shin-
ing through a window. It could also be reflective light,
such as from a pool or light colored wall.
To install the light shield, follow these simple steps.
1. Remove protective backing from the bottom of the
light shield.
2. Position light shield over the photocell with the
opening facing away from the interfering light.
3. Press the adhesive side firmly against the photocell
to mount it permanently in place.
Light
Shield
598-1160-05
SPECIFICATIONS
Horizontal Range . . . . Up to 70 ft. (21 m); 100 ft.
Vertical Range . . . . . . Up to 15 ft. (4.6 m)
Sensing Angle . . . . . . Up to 240° horizontal. Up to 80°
Electrical Load . . . . . . Up to 300 Watt Maximum Tung-
Power Requirements . 120 VAC, 60 Hz
Operating Modes . . . . TEST, AUTO, and MANUAL
Time Delay . . . . . . . . 1, 5, 20 minutes
Replacement bulb . . . T3, 150W halogen maximum
D
B
®
ual
rite
HeathCo LLC reserves the right to discontinue prod-
Protective
ucts and to change specifications at any time without
Backing
incurring any obligation to incorporate new features in
products previously sold.
5
(30.5 m) with Range Boost.
[var ies with surrounding
temperature]
Vertical
sten Halogen [Up to 150 Watt
Maximum each bulb holder.]
MODE
120 VAC
Timer . . . . Off, 3, 6 hours, Dusk-to-Dawn
Advertisement
Table of Contents
