Using The Built-In Battery; Turning On The Unit - SONIQ PD70 User Manual

Table of Contents

Advertisement

Power Supply
C. Using the Built-in Battery
The unit has a built-in, non-replaceable, rechargeable battery. Charge the built-in battery before using it
for the first time. The normal charging time should be within 4-5 hours. The charging light will go out when
the built-in battery becomes fully charged.
To Recharge the Built-in Battery
1
To AC outlet
AC adaptor
Slide the switch
3
to CHARGE
Warnings:
• The built-in battery can only be recharged when the unit is in CHARGE mode while using the AC adaptor.
• The built-in battery cannot be recharged when the unit is in power ON mode.
• The unit should not be exposed to excessive heat such as sunshine, fire or the like.
Cautions:
• The AC adaptor included with this unit is for its use only. Do not use it with other equipment.
• When the unit is not going to be used for long time, disconnect the AC adaptor from the AC outlet.
• When the AC adaptor is plugged in, the apparatus is not completely disconnected from the mains, even
when the unit is turned off.
Condition and attention:
• When the built-in battery power is low, "
• Recharge the built-in battery when you are ready to use it again.
• While using the built-in battery, the environmental temperature should be 5°C (41°F) to 35°C (95°F).
• To get the longest service life of the built-in battery, charge at indoor-temperature.
• The built-in battery in this device may present a risk of fire or chemical burn if mistreated. Do not
disassemble, heat above 100°C (212°F), or incinerate.
• The unit should not be exposed to excessive heat such as sunshine, fire or the like.
• When discarding the unit, environmental problems must be considered and local rules or laws govering
the disposal of such products must be strictly followed.

Turning On the Unit

1. Slide the CHARGE / STANDBY / ON switch on the left side of the unit to the ON
position.
2. The DVD logo (start-up picture) will appear on the screen.
3. After use, slide the CHARGE / STANDBY / ON switch to the STANDBY position.
To DC IN
2
9V-12V jack
5
" will display on the screen and the unit will stop playing.
-7-
R e c h a r g i n g i s
completed when
charging light
goes out
4
Charging light ON

Advertisement

Table of Contents
loading

Table of Contents