Subscribe to Our Youtube Channel
Related Manuals for Firefly OL0308
Summary of Contents for Firefly OL0308
- Page 1 Instruction Manual Infrared Heater Please read these instructions carefully before using your new heater...
- Page 2 Before each use check: • that the thermostat is switched on • that there is no damage to the wiring • that the heater is plugged in Warning: It can be dangerous to install heater near curtains and other combustible materials. Never wrap the power cord around the heater as this can damage it.
- Page 3 Mount and fix the L shape legs on the wall and on the unit respectively, using the M8×13 bolts and nuts and the washers as shown in (Figure-3) and tighten by using the wrench supplied. Figure-4 Depending on the area to be heated the angle of the unit can be adjusted between 0-45 degrees by the help of M8 Bakelite head bolt and nut fixture.
-
Page 4: Operating Instructions
Step 3：Press Open/Close second，the digital screen shows P.1，the function of a file connected Step 4：Press Open/Close third，the digital screen shows P.2，the function of two file connected Step 5：Press Open/Close forth，the digital screen shows P.3，the function of three file connected Step 6：After the function is on，1-24 hours timing shutdown can be adjusted arbitrarily， the digital screen showing 0.1 indicates timing one hour，showing 0.2 indicates timing two hour. - Page 5 Remote Control 1. Power indicator When in use, press any button, the red indicator will flash. 2. On / Off Switches on or off the heater or stands it by. 3. First gear After turn on the heater, you can choose low heating. 4.
- Page 6 Notice: 1- Replace the old batteries with the same type batteries. Otherwise, your heater may not function well. 2- Pull out the batteries in case of long terms of disuse to prevent leakage which may impair your remote control. 7.2 Operation of the Remote Control 1.
- Page 7 7.3 Manual Operation Control through the main module on the heater: P0 indicator appears on the screen when the heater is switched on and it is in stand by mode. The 1 digit on the screen illustrates P symbol while 2 digit illustrates power level mode from 1 to 3.
-
Page 8: Care And Maintenance
Care and maintenance Ensure that the heater is disconnected and cleaned periodically. To clean the heater: 1. Disconnect the power cable 2. Remove the safety bars 3. Wipe the front with a soft damp cloth. Use a gentle detergent. Be careful to clean the surface very carefully without leaving finger prints or scratches.
Need help?
Do you have a question about the OL0308 and is the answer not in the manual?
Questions and answers