Table of Contents
Advertisement
Before getting underway, operations checks should be completed to ensure a safe and enjoyable
outing. Verify that:
q All safety requirements as outlined in the Safety section of this Owner's Manual have been met.
q Review the pre-launch requirements as outlined by the trailer manufacturer, and the preparations as
required by the engine/drive-train manufacturer.
q The total number of people and gear on-board does not exceed the maximum allowed and as indicated
on the capacity plate. These informational plates are located in the interior near the driver's helm.
q All gear is properly stowed. Gear that is left loose on the deck can become dislodged, move about
during operation and could potentially go overboard or strike an individual on-board, resulting in
potential injury.
q A float plan or outing information has been left with someone ashore. This means that if any issues
arise, there is a person to raise an alarm if you do not return as planned. (Cell phones are great, but
sometimes service is not available, so this should not be the only plan in the event of problems.)
q Ensure there is sufficient fuel in the fuel tank for the outing or have a plan for re-fueling.
q Be sure that the weather forecast does not include threatening conditions. Also check predicted wind
and water conditions.
q Check that the drain plugs are all fully and correctly installed.
q Ensure that PFDs and other safety gear are on-board.
q Be sure that all on-board fire extinguishing equipment is fully charged and easily accessible.
q Go through the pre-outing maintenance checklist, as outline in the Care and Maintenance section of
this Owner's Manual.
q Give all the on-board equipment and components (such as the tower) a final check to be certain that
everything is secure and ready for the expected boating conditions.
2016 Axis Wake Research Owner's Manual . . . Page 3-3
FINAL
CHECKS
BEFORE
STARTING
Advertisement
Table of Contents
