Solmeta Geotagger Pro User Manual page 10

Solmeta geotagger Pro
Note
In our earlier version, the Pro will be able to output the last one GPS information stored in the memory
as soon as you turn it on and before it acquires new GPS signal. However, we got feedback from our
clients that those" previous" GPS data might cause a lot of trouble and lead to incorrect locations. In
order to avoid this, Solmeta has improved the "Indoor fix" function.Only when your Pro device is keeping
on and you are into a place where is no GPS signal, the Pro is able to provide the last GPS information.
As soon as you turn off the Pro, the GPS data stored in Memory is invalid.
3. Local time shown on LCD setting
Select the current time shown on LCD with UTC time or local time. (UTC time is shown on the LCD by
default) With the UTC time available, please follow the procedure below to get a local time shown on
the LCD.
1. On the "Tim" display mode, short press the
2. Short press the
the left of the screen ,
short press the
3. Short press the
the ENTER
4. Backlight setting
The backlight can last one minute and meanwhile the function of long-lasting backlight is also available.
Here are the steps of how to operate.
1. On the "LON" display mode, press the
2. On the "LON" display mode, press the
5. System resetting
Once you perform a firmware upgrade or a compass calibration, a system resetting is required. Please
follow the procedure below.
1. Turn the Pro on, firmly press down the
changes to the reset mode screen as below, a "RESET" icon is blinking on the LCD.
2. Then short press the
MENU button again to get the change (you can see a blinking icon
"L" is local time ,
ENTER button to enter the time zone setting.
MENU button, you can add or minus the time zone for your local time. Press
button to complete the setting.
ENTER button to confirm the system reset.
ENTER button to enter the setting mode.
"U" is UTC time). On the "L" icon blinking status,
ENTER button to activate.
ENTER button again to exit.
ENTER and the MENU
8
L
button together until the LCD
R
or U on