Bluetooth System - GMC Yukon Owner's Manual

To Transfer Audio to the In-Vehicle

Bluetooth System

The cellular phone must be paired and connected with
the Bluetooth system before a call can be transferred.
The connection process can take up to two minutes
after the key is turned to the ON/RUN or ACC/
ACCESSORY position.
During a call with the audio on the cell phone,
g
press for more than two seconds. The audio
switches from the cell phone to the vehicle.
Voice Pass-Thru
Voice Pass Thru allows access to the voice recognition
commands on the cell phone. See the cell phone
manufacturers user guide to see if the cell phone
supports this feature. This feature can be used to
verbally access contacts stored in the cell phone.
1. Press and hold
responds with Ready followed by a tone.
2. Say Bluetooth . The system responds with
Bluetooth ready followed by a tone.
3. Say Voice . The system responds with
OK, accessing <phone name> .
The cell phone's normal prompt messages will
go through its cycle according to the phone's
operating instructions.
4-124
g
for two seconds. The system
Dual Tone Multi-Frequency (DTMF)
Tones
The in vehicle Bluetooth system can send numbers and
numbers stored as name tags during a call. This is used
when calling a menu driven phone system. Account
numbers can be programmed into the phonebook for
retrieval during menu driven calls.
Sending a Number During a Call
g
1. Press . The system responds with Ready
followed by a tone.
2. Say Dial . The system responds with Say a
number to send tones followed by a tone.
3. Say the number to send.
If the system clearly recognizes the number it
responds with OK, Sending Number and the
dial tones are sent and the call continues.
If the system is not sure it recognized the
number properly, it responds Dial Number,
Please say yes or no? followed by a tone.
If the number is correct, say Yes . The system
responds with OK, Sending Number and the
dial tones are sent and the call continues.