Renegade Wiring Harness; 6-Position Connector On Wiring Harness For Trailer - lehman Trikes Renegade Installation Instructions Manual

Renegade Wiring Harness

1. See Fig.'s 1-2. Attach wiring harness to body
clips on underside of body.
2. Connect 8 position connector on wiring harness
(Fig. 3) to OEM harness, located under rider
seat at rear of OEM frame.
Body clip
License plate connector
3. See Fig.'s 4-5. Before connectinglicense plate and light bar (optional) to harness, terminals and
connectors will need to be installed to each before connecting to wiring harness. Use appropriate
tool for crimping terminals to wires. (Mac Tools– TCT1028, Blue Point– PWC47 or H-D 41609).
4. See Fig. 5. Inspect crimps before installing into connector. Distortion should be minimal.
Male terminal
Female terminal
Fig. 2
Fig. 4
Light bar
connector
on RH side
8-position connector on wiring harness-main

6-position connector on wiring harness for trailer

Wire core crimp
26
1997-2001 FLH Renegade– Rev. 3
Fig. 1
Taillight connector
Body clips
Fig. 3
Fig. 5
Insulation crimp