Lights And Wiring - lehman Trikes Renegade Installation Instructions Manual

Lights and Wiring

Caution: Use care with painted surfaces
1. See Fig. 1. Drill 15/16" hole for turn signal on flat
below taillight. Center turn signal with inside edge
of taillights. Mount H-D turn signals using original
bolts with supplied washers (CW2001).
NOTE: Do not over tighten taillight mounting hard-
ware. Damage to housing may occur.
2. See Fig 2. Mount taillight assemblies to body with
gaskets. Attach ground wire to stud with flange
nut after taillight mounting hardware is installed.
•
(2) Taillight Assembly-S002204
•
(2) Gaskets– BG0200
•
(4) 1/4" Flat Washer– CW2006
•
(4) Lock washer– Provided with light
•
(4) Nut– Provided with light
•
(2) 1/4" Flange Nut– CN3007
3. See Fig's 3 & 4. If required- Install female terminals
and male connectors to taillight wiring Use appropriate
tool for crimping terminals to wires. (Mac Tools–
TCT1028).
4. See Fig's 3 & 4. Inspect crimps before installing into
connector. Distortion should be minimal.
Mount signal
to body
Female Terminal
24
1997-2001 FLH Renegade– Rev. 3
Fig. 1
Fig. 2
Attach ground wire to stud
Fig. 3
Insulation crimp
Wire core crimp