Canon EOS REBEL T6S Instruction Manual page 369

Transmission status icon
H
(Gray) Not connected : No connection with access point.
H
(Blinking) Connecting...: Connecting to access point.
H
(Illuminated) Connected: Connection to access point established.
H
() Transferring...
Cautions for Using Eye-Fi Cards
If [51:Wi-Fi/NFC] is set to [Enable], image transfer with an Eye-Fi card

is not possible.
If "J" is displayed, an error occurred while retrieving the card

information. Turn the camera's power switch off and on again.
Even if [Eye-Fi trans.] is set to [Disable], it may still transmit a signal. In

hospitals, airports, and other places where wireless transmissions are
prohibited, remove the Eye-Fi card from the camera.
If the image transfer does not function, check the Eye-Fi card and

computer settings. For details, refer to the card's instruction manual.
Depending on the wireless LAN's connection conditions, the image

transfer may take longer or it may be interrupted.
The Eye-Fi card may become hot as it transmits.

The battery power will be consumed faster.

During the image transfer, auto power off will not take effect.

If you insert a wireless LAN card other than an Eye-Fi card, [Eye-Fi settings]

will not appear. Also, the transmission status icon <H> will not appear.
Check the [Access point SSID:].
5
Check that an access point is

displayed for [Access point SSID:].
You can also check the Eye-Fi card's

MAC address and firmware version.
Press the <M> button three times

to exit the menu.
Take the picture.
6

The picture is transferred and the
<H> icon switches from gray (not
connected) to one of the icons below.
For transferred images, O is

displayed in the shooting information
display (p.320).
: Image transfer to access point in progress.
H Using Eye-Fi Cards
369