Erasing Homelink Buttons; Reprogramming A Single Homelink Button; Message Center; Selectable Features - Ford 2009 Taurus Owner's Manual

Erasing HomeLink buttons

To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink is now in the train (or learning) mode and can be
programmed at any time beginning with Step 1 in the Programming
section.

Reprogramming a single HomeLink button

To program a device to HomeLink using a HomeLink button previously
trained, follow these steps:
1. Press and hold the desired HomeLink button. Do NOT release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink button, follow Step 1 in the Programming
section.
For questions or comments, contact HomeLink at www.homelink.com
or 1–800–355–3515.

MESSAGE CENTER

With the ignition on, the message
center, located on your instrument
cluster, displays important vehicle
information through a constant
monitor of vehicle systems. You
may select display features on the
message center for a display of status. The system will also notify you of
potential vehicle problems with a display of system warnings followed by
a long indicator chime.

Selectable features

Reset
Press this control to select and reset functions shown in the INFO menu
and SETUP menu.
2009 Taurus (500)
Owners Guide, 2nd Printing
USA (fus)
Driver Controls
83