RedMax PSZ2500 Owner's/Operator's Manual page 22

8. Operation
OP7
OP8
.04 in
(1~2mm)
OP9
22
Adjust the pump as follows:
1. Stop the engine and make sure the stop switch
2. Place the unit on its side with the oil reservoir
(1) Oil tank (2) Chain cover
The oil flow adjusting screw must be pressed in
slightly in order to turn. Failure to do so could
damage the pump and screw.
3. With a screwdriver, push in on the oil flow rate
(a) Clockwise-decrease lubrication.
(b) Counter clockwise-increase lubrication.
(c) Middle
• The normal play is 1 or 2mm when measured at
(1) cable adjuster
(1)
1. When the engine tends stop frequently at idling
2. When the cutting head keeps rotating after
(1) idle adjusting screw
• Warm up the engine before adjusting the idling
(1)
• Always wear work gloves made of leather or
• Falling branches may fall onto the face or
is in the OFF position.
up. (OP7)
IMPORTANT
adjusting screw and turn in the desired direction
(there are three incremental settings):
ADJUSTING THROTTLE CABLE
the carburetor side end. Readjust with the cable
adjuster as required. (OP8)
ADJUSTING IDLING SPEED (OP9)
mode, turn the adjusting screw clockwise.
releasing the trigger, turn the adjusting screw
counter-clockwise.
NOTE
speed.
WARNING
some other sturdy material when using the
polesaw.
into the eyes, resulting in injuries, scratches,
and cuts, and for this reason you should
always be sure to wear a helmet and face
protector when using your polesaw.