RedMax PSZ2500 Owner's/Operator's Manual page 16

6. Set up
SE4
SE5
SE6
SE7
16
A standard package contains the items as shown
below. (SE4)
(1) Guide bar
(2) Saw chain
(3) Gase case
(4) Sprocket
(5) Chain tension adjust screw
(6) Nut
(7) Chain tensioner nut
(8) Chain cover
Install the guide bar and the saw chain on the gear
case as follows.
WARNING
The saw chain has very sharp edges. Use
protective gloves for safety.
1. Loosen a nut and remove the chain cover.
2. Mount the guide bar then fit the saw chain
around the bar and sprocket.(SE5)
WARNING
Pay attention to the correct direction of the saw
chain
3. Fit the chain tensioner nut into the lower hole of
the guide bar, then install the chain cover, and
fasten the mounting nut to finger tightness.
(SE5)(SE6)
(1) Hole
(2) Moving direction
(3) Chain tensioner nut
4. Adjust the chain tension by turning the tensioner
screw until the tie straps just touch the bottom
side of the bar rail. (SE7)
(1) Chain tension adjusting screw
(a) Loosen
(b) Tighten