Adjusting Airflow Direction - Panasonic S-12MU1U6 Operating Instructions Manual

162011_VRF_EN.fm Page 7 Friday, September 30, 2011 9:27 AM
4-way type (U1, Y1)
Indoor unit
Zone ''A''
for cooling
30°
60°
Zone ''B'' for
heating

ADJUSTING AIRFLOW DIRECTION

4-way (U1) and 1-way (D1) air conditioners are equipped with auto flaps.
You can set the airflow direction to a specific angle or to the sweep mode using the remote
controller.
Do not move the flap with your hands.
• The air outlet flap can be easily removed and washed with water.
• Be sure to always stop operation before removing the flap.
• After washing with water, allow it to dry, and then remount it with the arrow facing outward.
Ceiling type (T1)
A. Vertical directions (automatic)
This air conditioner is equipped with an auto flap. You can set the airflow direction to a specific
angle or to the sweep mode using the remote controller. (Refer to the description of the remote
controller.)
Do not move the flap with your hands.
B. Horizontal directions (manual)
The horizontal airflow direction can be adjusted manually by moving the vertical vanes to the
left or right.
Wall mounted type (K1)
A. Vertical directions (automatic)
Confirm that the remote controller has been turned on. Press the FLAP button to start the flap
moving up and down. If you want to stop the flap movement and to direct the air in the desired
direction, press the FLAP button again. In the cool mode, don't direct the flap down more than
30°, otherwise, condensation may drip on to the floor. Zone ''A'' is the recommended flap
position for cooling.
Do not move the flap with your hands.
B. Horizontal directions (manual)
The horizontal airflow direction can be adjusted manually by moving the vertical vanes to the
left or right.
7