Sar; Sar Value - iBall Slide Octa-A41 User Manual

Class 4 SD card 4 MB/sHD recording including full HD (from 720p to 1080p/1080i)
Class 6 SD card  6 MB/s HD recording including full HD (from 720p to 1080p/1080i)
Class 10 SD card 10 MB/sFull HD (1080p) video recording and consecutive recording of HD stills
For HD video recording a SD card of class 6 or higher is suggested because of the constant stream of data that needs to be
written. If you will use a class 2 SD card for HD video recording, the video will sufferer dropouts and you will get a corrupted
video.
Charging the Battery
New batteries are shipped partially charged. Before you start using your device, it is recommended that you charge the battery.
Some batteries perform best after several full charge/discharge cycles.
The battery can be charged and discharged many times, but it will eventually wear out. When the talk and standby times are
noticeably shorter than normal, get the battery replaced. Use only iBall approved batteries, and recharge your battery only with
iBall approved chargers designated for this device. If a battery is being used for the first time or if the battery has not been used
for a prolonged period, it may be necessary to connect the charger, then disconnect and reconnect it to begin charging the
battery. If the battery is completely discharged, it may take several minutes before the charging indicator appears on the display
or before any calls can be made.
Note: Only the AC adapter provided with your device must be used to charge the device.
Connect the USB connector of the AC adapter to the sync connector on your device and then plug in the AC adapter to an
electrical outlet to start charging the battery.
As the battery is being charged while the device is on, a charging icon appears in the title bar of the Home screen. After the
battery has been fully charged, a full battery icon appears on the title bar of the Home screen.
Warning!
• As a safety precaution, the battery stops charging before it overheats.
Protect environment save energy
You do not need to charge your Slide battery so often if you do the following:
Close applications and data connections, for example, your Bluetooth connection, when not in use.
Deactivate unnecessary sounds, such as touch screen and key tones.

SAR

This device is SAR accredited adheres to international quality benchmarks and safety measures concerning the harmful impact
of radiations. It complies with applicable safety requirements for exposure to radio waves. The radio waves exposure guidelines
employ a unit of measurement called Specific Absorption Rate (SAR). SAR is a measure of the rate at which energy is
absorbed by the body when exposed to a radio frequency (RF). SAR is usually averaged either over the whole body, or over a
small sample volume (typically 1g or 10g of tissue). The recommended SAR limit for a mobile handset/similar device is 1.6
W/Kg averaged over a volume containing a mass 1g of human tissue.

SAR Value

• Your Slide is designed not to exceed the limits of emission of radio waves recommended by international guidelines.
7