Mecha Adj Screen - Kenwood DDX6027Y Service Manual

DDX6027/6027Y/7017
DDX7037/7047/7067
QQ
3 7 63 1515 0

MECHA ADJ Screen

• Panel mecha position adjustment is to be conducted.
MECHA ADJ screen
MECHA Adjust
Key Specification
MECHA Adjust: Mecha position adjustment will begin.
Return: Test Mode Main Screen is displayed.
MECHA Adjust in progress
MECHA Adjust
TE
L 13942296513
MECHA Adjust complete
MECHA Adjust
Note: In case of NG, enter the Test Mode again and re-do
from the beginning.
www
.
34
Return
Mecha Adjusting
Return
Mecha Adjust OK/NG
Return
x ao
y
i
TEST MODE
8
Chroma Screen
• Chroma data adjustment will be conducted.
• Adjustment is conducted with a remote controller (Audio
SW).
Note: Chroma data on the EEPROM can be cleared with
the Clear key in the Service screen.
C H : ∗∗ ∗ ∗ ∗ ∗ ∗
V A L ∗ ∗
Key Specification (Remote Controller)
Direct : Chroma IC Adjustment Mode ON/OFF (EEPROM
writing)
Play/Pause: Chroma setting value Confirm/Rehearse
Tenkey 7: Chroma adjustment To the next item.
Tenkey 8: Chroma setting value change (UP)
Q Q Tenkey 9: Chroma adjustment To the next item.
3 6 7 1 3
Tenkey 0: Chroma setting value change (DW)
Source / Set Up / Audio Screen
• The same as the normal screen (Other than Test Mode).
However, when SetUp key and Audio key are pressed, re-
turns to Test Mode Main screen.
Security Code Writing Screen
• Security code is managed in pair with serial number. Secu-
rity Code is written in this screen. (Other than K/R destina-
tions)
• From Set Up screen, press Security Set Up key.
• In case of other than K/R destinations, only when EEPROM
Security Code is blank, Set key is displayed. Press the key.
• The same operation as the regular Security Code registra-
tion is to be conducted in the Security Code Writing screen.
When Enter key is pressed, writing begins.
Note: The Security Code to be input here must be the unique
code of the set liked with the serial number.
• When "Complete" is displayed, normal ending. When NG is
displayed, error.
Note: In case of NG, enter the Test Mode again and re-do
u163
from the beginning.
.
2 9 9 4 2 8
1 5 0 5 8 2 9 9 4
m
co
9 9
2 8 9 9