Table of Contents
Advertisement
x Changing the "Channel Setup"
setting
The "Channel Setup" menu allows you to adjust settings below.
1
Press WEGA GATE and select "Settings".
2
Press V or v to select the "Channel Setup"
icon (
), then press
3
Press V or v to select the desired item (e.g., "Cable"), then press
Select
"Cable"
"Auto Program"
"Program Edit"
"FM Radio Setup"* preset up to nine FM radio stations.
.
To
receive cable TV programs.
Press V or v to select "On", then press
If you select "Cable: On", you will be able to receive 125 cable TV
channels.
If there are no cable TV channels, you will receive VHF broadcast
channels only.
To receive only VHF and UHF broadcast channels, select "Off", then
press
.
preset channels automatically.
label the program number, skip the program number and block
unwanted programs (see step 3 of the section "Initial Setup" in
page 6).
You can manually preset each FM radio station that can be received
in your area and then store the radio frequency of the desired FM
radio stations.
(1) Press V or v to select the desired FM radio station position,
then press
.
(2) Press V or v to search the FM radio stations.
Searching stops automatically when a station is tuned in.
If the station has a weak signal, press B or b to fine tune the
radio frequency manually, then press
radio station.
(3) You may edit the FM radio station label. Press V or v to
select alphanumeric characters for the label, then press
(4) Repeat steps (1) through (3) to preset other FM radio stations.
* The "FM Radio Setup" feature is only available in FM Radio
mode. To enable this feature, access to FM Radio mode by using
WEGA GATE system (see page 16) or pressing the FM button
on the front panel (see page 8), then preset your desired FM
radio stations according to the steps mentioned above.
Channel Setup
Cable:
On
Auto Program
Program Edit
FM Radio Setup
Select
Confirm
End
.
.
to store the FM
.
Menu Adjustment
21
Advertisement
Table of Contents
