Assembly
* Note: For dissembling/(re)assembling this product, lead-free solder is used except for both ends of Xe-tube.
・For assembling work for both ends of Xe-tube on Page A3, use lead solder. For the other all works,
use lead-free solder.
Reflector
・Attach the conductive tape (#82) on the reflector (#77).
・Solder the trigger lead wire (#184).
・Attach the reflector to the reflector case (#75).
* Note: Hook the notches of the reflector to 4 parts of
the reflector case.
Reflector side plate
・Attach 2 shade sheets (#185) inside the reflector side plates (#79, #80).
・Attach the reflector side plate to the reflector case.
・Attach 2 screws (#81).
Surface with wider spacing
between notches
#185
#80
- A1 ・ SB-800 -
FSA03501-R.3613.A
#185
#79