IROX ETG918 Operating Instructions

Irox thermo/hygrometer operating instructions

ETG918

Operating Instructions

1- FIRST STEPS

Place the thermo/hygrometer near a window. Hang it on the wall or place it on a nearby table.

Lead the cable together with the sensing element through the open window to the outside. The

cable adapts to the window sealing shape. But please take care of sharp-edged window

frames—avoid frequent opening and closing of the window.

Open the battery compartment and insert one battery (Type AAA) in the correct polarity.

Remove the protection foil from the LCD display. The unit is now ready to use.

Locations of Control

1. TEMP Button (to read MAX/MIN records of thermometer)

2. CLEAR Button

3. HUMIDITY Button (to read MAX/MIN records of hygrometer)

4. °C/°F Button

Feature

• Indoor-outdoor thermometer, indoor hygrometer

• Weather proof sensor wire (2.9m)

• Records minimum/maximum indoor/outdoor temperatures and indoor relative humidity.

• Celsius or Fahrenheit selectable.

• Temperature resolution: 0.1°C/ 0.1°F.

• Humidity resolution: 1%

Table of Contents

Do you have a question about the ETG918 and is the answer not in the manual?

Page 1 ETG918 Operating Instructions 1- FIRST STEPS Place the thermo/hygrometer near a window. Hang it on the wall or place it on a nearby table. Lead the cable together with the sensing element through the open window to the outside. The cable adapts to the window sealing shape.
Page 2 2- OPERATING THE PRODUCT Setting Celsius (°C) or Fahrenheit (°F) Format • Press °C/ °F button to toggle in between Celsius or Fahrenheit readout. Viewing Indoor and Outdoor Temperature Record • Press TEMP button once to read indoor Max and Min temperature. Press CLEAR button to clear indoor Max/Min temp data.
Page 3 3- IMPORTANT NOTES When the display becomes too faint, the battery needs to be replaced to assure the products accuracy and functionality. If any problem, remove the battery, test or replace the battery with a new one, then reinsert the good battery. Dispose of waste battery according to the national rules.
Page 4 EU (WEEE) have been paid. 6- SUPPORT This device is a new development of Irox Development Technology. All information was made and checked by means of a functioning instrument. It may occur that adjustments and improvements of the device will take place that due to typographical procedures were not able to be listed in this manual.