IROX ETHG912 - Electronic Thermo-Hygrometer Manual

Advertisement

IROX ETHG912 - Electronic Thermo-Hygrometer Manual

INTRODUCTION

This thermo-hygrometer has been designed specifically with performance and ease-of-use in mind. This thermo-hygrometer is made to the highest quality standards using precision electronic components and should give you many years of trouble free use.

Please read the User's Guide carefully before use to ensure you get the best out of your new thermo-hygrometer.

INDOOR THERMOMETER WITH RELATIVE HUMIDITY READING

The thermo-hygrometer is specially designed for accurate reading of indoor temperature and relative humidity. It can help you control humidity and your heating / cooling system, for an ideal living environment.

FEATURES

Easy Operation: Displays the temperature and relative humidity reading automatically.

Error-free Reading: Digital display system ensures clear, error-free reading at a glance.

Temperature compensation: Assures accurate relative humidity measurement unaffected by temperature change.

Comfort indicator: The comfort indicator lets you know when your environment is in the ideal range for both relative humidity and temperature.

Mounting: Table or wall-mount option.

INSTALLING THE BATTERY

The thermo-hygrometer is powered by one piece UM-4 or AAA size battery. Follow the below steps to install or replace the batteries:

  1. Open the battery cover on the back of the unit.
  2. Insert the battery as indicated by the polarity symbols (+/-) marked inside the battery compartment.
  3. Replace the battery cover.

NOTE

  1. When you install or replace the battery, it takes time to reset both the temperature and humidity data.
    The display will show '---°C' and '88%' for 1 to 2 seconds, then it shows the updated temperature and humidity reading.
  2. When the display becomes dim, replace the battery.
Indicator on the display Temperature
Range
Humidity
Range
Shows the current environment
COM 20ºC to 25ºC
(68ºF to 77ºF)
40% RH to
70% RH
(Comfort)
Ideal range for both relative humidity and temperature
WET 0ºC to 50ºC
(32ºF to 122ºF)
Over
70% RH
Contains excess moisture. (Too wet)
DRY 0ºC to 50ºC
(32ºF to 122ºF)
Below
40% RH
Contains inadequate moisture. (Too dry)

NOTE Some environments may exceed the above standards. When this happens, COM, WET or DRY will not appear on the display.

USE OF SUPPLIED STAND

You can set your thermo-hygrometer on a table as follows:

  1. Remove the plastic bracket.
  2. Flip out the built-in plastic stand on the back side of the thermo-hygrometer.

MOUNTING THE THERMO-HYGROMETER

Follow these steps to mount the thermo-hygrometer:

  1. The thermo-hygrometer has a plastic bracket with sticker pad on the back side of the bracket.
    Peel off the protective paper on the sticker pad for attaching the bracket on a wall.
  2. Slide the thermo-hygrometer down into the holder unit until it locks into place.

NOTE Do not place the thermo-hygrometer in direct sunlight or in area exposed to heavy saturation.

PRECAUTIONS

When handled properly, this unit is engineered to give you years of satisfactory service. Here are a few product care instructions:

  1. Do not immerse the unit in water. If the unit comes in contact with water, dry it immediately with a soft lint-free cloth.
  2. Do not clean the unit with alcohol containing detergent, abrasive or corrosive materials. Abrasive cleaning agents may scratch the plastic parts and corrode the electronic circuit.
  3. Do not subject the unit to excessive force, shock, dust, temperature, or humidity. Such treatment may result in malfunction, a shorter electronic life span, damaged batteries, or distorted parts.
  4. Do not tamper with the unit's internal components. Doing so will terminate the unit's warranty and may cause damage. The unit contains no user-serviceable parts.
  5. Only use new batteries as specified in this instruction manual. Do not mix new and old batteries as the old batteries may leak.
  6. Read this instruction manual thoroughly before operating the unit.

SPECIFICATIONS

Temperature: 0°C to 50°C (32°F to 122°F)
Measuring Range Temperature: 1°C (2°F)
Resolution Humidity: 25% RH to 95% RH at 25°C (77°F)
Measuring Range Humidity: 1% RH
Resolution Power Source: One (1) UM4 (AAA) battery
Battery Life: Approx. 6 months
Dimension: 93 x 62 x 15 mm (H x W x D)
Weight: 80 g (without battery)

  • The contents of this manual and the product specifications are subject to change without further notice.
  • The technical specifications of this product are subject to change without notice.
  • The contents of this manual may not be reproduced without the permission of the manufacturer.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download IROX ETHG912 - Electronic Thermo-Hygrometer Manual

Advertisement

Need help?

Need help?

Do you have a question about the ETHG912 and is the answer not in the manual?

Questions and answers

Table of Contents