Operation; Optional Accessory - Makita DUB362 Instruction Manual

Speed change
1
015477
The maximum air volume can be adjusted
just by turning the adjusting dial. This can
be done even while the tool is running. The
dial is marked 1 (lowest) to 6 (highest).
NOTICE:
The speed adjusting dial can be turned
only as far as 6 and back to 1. Do not
force it past 6 or 1, or the speed adjusting
function may no longer work.
When working in a high temperature
circumstance, the tool may be stopped
because of
system. In that case let the tool cool down.
Avoid setting to speed 6 (highest) in high
temperature circumstances.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off
•
and the battery cartridge is removed before
carrying out any work on the tool.
Installing the long nozzle
2
1
015480
To install the long nozzle:
1. Align the small projection of the housing
with the groove of the long nozzle.
2. Slide in the long nozzle, and turn it
clockwise until the triangle markings
on the long nozzle and the housing
meet each other.
1. Adjusting dial
the overheat protection
1. Long nozzle
2
2. Triangle marking
015481
The length of the nozzle can be adjusted by
changing the locking position.
Installing the shoulder strap

(optional accessory)

015482
Hook the shoulder strap onto the hanger of
the tool.
Before use, adjust the length of strap so
that it is easy to work with it.

OPERATION

Blowing
015484
CAUTION:
Do not place the blower on the ground
•
while it is switched on. Sand or dust
may enter from suction inlet, and they
may result in personal injury.
Hold the blower firmly with a hand and perform
the blowing operation by moving it around slowly.
When blowing around a building, a big stone or
a vehicle, direct the nozzle away from them.
When performing an operation in corner, start
from the corner and then move to wide area.
7