L70S Technical Service Manual Safety Precaution WARNING Service should not be attempted by anyone unfamiliar with the necessary precautions on this monitor. The followings are the necessary precautions to be observed before servicing. 1. When managing this monitor , cover with shield plate to avoid to scrach on LCD surface.
Control Description Front View Power Switch / LED Indecator Support Modes Dot Clock V Frequency H Frequency Resolution (Hz) (kHz) (MHz) Polarity Polarity 720 x 400 28.322 70.1 31.5 640 x 480 25.175 59.9 31.5 640 x 480 31.500 75.0 37.5 40.000 800 x 600...
L70S Technical Service Manual Video Input Signal Recommended signal are shown below •Video Signal Video level : 0 to 700mV Polarity : positive Video Input : RGB separated Analog level Sync input : H-Sync(TTL level) V-Sync (TTL level) •Waveform Video input(R.G.B) 700mV •...
Video Input Terminal A 15 Pin D-sub connector is used as the input signal connector Pin and input signals are shown in the table below. Pin Description SEPARATE SYNC/ SIGNAL DDC 1/2B PIN NO. GREEN BLUE RETURN RED GROUND GREEN GROUND BLUE GROUND LOGIC GROUND GROUND...
L70S Technical Service Manual Connecting with External Equipment Cautions Be sure to turn off the power of your computer before connecting the monitor. LINE OUT --5--...
Theory of Operation 1. AC/DC INVERTER Input voltage : DC 12V Input current : 2.0A(Max) Output current : 6.5mArms(TYP) Frequency(switching) : 47KHz(Max) Output power : 18W(TYP) On/off control voltage : 5.0V 2. AC/DC ADATOR This display device shall maintain the specified per formances in the range de scribed below Frequency : 50/60Hz Voltage : 90 - 264Vac RMS...
Page 8
L70S Technical Service Manual On Screen Controls & LED Indicator The menu for screen setting adjustment is located in the OSD and can be viewed in one of five languages OSD feature andmain funcrions are as follows: 1280x1024 H:63.9 V:60.0...
CLOCK PHASE PHASE Adjust the noise of the screen image. CLOCK Adjust the horizontal size of the entire screen image. MISCELLANEOUS RECALL Recall the saved color data. OSD TIMER You can set the displayed time of OSD Menu window on the screen by using this adjustment.
Page 10
L70S Technical Service Manual Getting Fine Picture Step 1. At first Display, a full screen, such as, Window's background or "H" character should be achieved by using Editor (ex: Notepad. exe) Step 2. Adjust the screen to the center of the Display(LCD), by using the top and bottom display controls.
L70S Technical Service Manual Critical Parts Specification 1. LCD Module M170EN05(LTM170EU-L01, HT17E12-100 is a a-si TFT active matrix color liquid crystal comprising amorphous silicon TFT attached to each signal electrode, a driving circuit and a backlight. M170EN05(LTM170EX-L01, HT17E12-100 has a built-in backlight display area contains...
Page 13
2) CONNECTIONS Physical interface is described as for the connector on module. These connectors are capable of accommodating the following signals and will be following components Connector Name / Designation Interface Connector / Interface card Manufacturer JAE or compatible Type Parts Number FI-X30S-HF Mating Housing Part Number FI-X30S-H...
Page 14
L70S Technical Service Manual 4) Signal Description The module using a pair of LVDS receiver SN75LVDS82 (Texas Instruments) or compatible. LVDS is a differential signal technology for LCD interface and high speed data transfer device. Transmitter shall be SN75LVDS83(negative edge sampling)or compatible. The first LVDS port(RxOxxx)transmots odd pixels while the second LVDS port(RxExxxx)transmits even pixels.
MST9111 GENERAL DESCRI PTION The MST9111 is a high performance, and fully integrated graphics processing IC solution for LCD monitors with resolutions up to SXGA. It is configured with an integrated triple-ADC/PLL, a high qualit scaling engine, an on-screen display controller, a built-in output clock generator, and LVDS displa interface.
Page 16
L70S Technical Service Manual PIN DIA G RAM...
24LC08 24C08 24C08 24LC08 24LC08 Dual-In-Line SO package package (M8) 24C08 24LC08 TSSOP Pin Name A0, A1 N.C. Device Address inputs Ground Data I/O Clock input Write Protect + 5 V or + 3 V 3.0 ABSOLUTE MAXIMUM RATINGS Storage Temperature........-65°C to + 125°C Voltage with Respect to Ground....-0.3 to + 6.5 V NOTE: These are STRESS rating only.
L70S Technical Service Manual 5.0 ELECTRICAL CHARACTERISTICS DC ELECTRICAL CHARACTERISTICS (Vcc =5V +/- 10% ,MTV24C08/24LC08° F V cc =3V +/- 10% ,24LC08) MTV24C08/ 24LC08 24LC08 Units Symbol Parameter Conditions SCL = 100KHZ — — Operating Current CMOS Input Levels (Program)
Page 19
CAPACITANCE TA= 25∞ C , f=250KHZ Symbol Parameter Units Output capacitance Input capacitance A. C. Conditions of Test Input Pulse Levels Vcc x 0.1 to Vcc x 0.9 Input Rise and Fall times 10 ns Input and Output Timming level Vcc x 0.5 Output Load 1 TTL Gate and...
L70S Technical Service Manual RC1117 RC1117X2.5 1A Adjustable/Fixed Low Dropout Linear Regulator Features Description • Low dropout voltage The RC1117 and RC1117-2.5, -2.85, -3.3 and -5 are low • Load regulation: 0.05% typical dropout three-terminal regulators with 1A output current •...
Pin Assignments Tab is Tab is Front View Tab is ADJ/GND 4-Lead Plastic SOT-223 = 15 C/W* ADJ/ ADJ/ 3-Lead Plastic TO-252 3-Lead Plastic TO-263 = 3 C/W* = 3 C/W* *With package soldered to 0.5 square inch copper area over backside ground plane or internal power plane., can vary from 30°C/W to more than 50°C/W.
Page 22
L70S Technical Service Manual Electrical Characteristics Operating Conditions: V 7V, T = 25°C unless otherwise specified. The denotes specifications which apply over the specified operating temperature range. Parameter Conditions Min. Typ. Max. Units Reference Voltage, V 1.5V 5.75V, 1.225 1.250 1.275...
Page 23
RC1117-3.3 1A Adjustable/Fixed Low Dropout Linear Regulator Features Description • Low dropout voltage The RC1117 and RC1117-2.5, -2.85, -3.3 and -5 are low • Load regulation: 0.05% typical dropout three-terminal regulators with 1A output current • Trimmed current limit capability. These devices have been optimized for low voltage •...
L70S Technical Service Manual Pin Assignments Tab is Tab is Front View Tab is ADJ/GND 4-Lead Plastic SOT-223 = 15 C/W* ADJ/ ADJ/ 3-Lead Plastic TO-252 3-Lead Plastic TO-263 = 3 C/W* = 3 C/W* *With package soldered to 0.5 square inch copper area over backside ground plane or internal power plane., can vary from 30°C/W to more than 50°C/W.
Page 25
Electrical Characteristics Operating Conditions: V 7V, T = 25°C unless otherwise specified. The denotes specifications which apply over the specified operating temperature range. Parameter Conditions Min. Typ. Max. Units Reference Voltage, V 1.5V 5.75V, 1.225 1.250 1.275 10mA (-2%) (+2%) Output Voltage 10mA RC1117-2.5, 4V...
Page 26
L70S Technical Service Manual SI4435 PD- 93768A Si4435DY Æ HEXFET Power MOSFET Ultra Low On-Resistance P-Channel MOSFET = -30V Surface Mount Available in Tape & Reel = 0.020Ω DS(on) T o p V ie w Description Æ These P-channel HEXFET...
Page 27
Si4435DY Electrical Characteristics @ T = 25∞C (unless otherwise specified) Parameter Min. Typ. Max. Units Conditions Drain-to-Source Breakdown Voltage ñññ ñññ = 0V, I = -250µA (BR)DSS ∆V Breakdown Voltage Temp. Coefficient ñññ -0.019 ñññ V/∞C Reference to 25∞C, I = -1mA /∆T (BR)DSS...
L70S Technical Service Manual TDA7496L 2W+2W AMPLIFIER WITH DC VOLUME CONTROL 2W+2W OUTPUT POWER = 8Ω @THD = 10% V = 14V ST-BY AND MUTE FUNCTIONS LOW TURN-ON TURN-OFF POP NOISE LINEAR VOLUME CONTROL DC COUPLED WITH POWER OP. AMP.
ABSOLUTE MAXIMUM RATINGS Symbol Parameter Value Unit DC Supply Voltage Maximum Input Voltage Total Power Dissipation (T = 60∞ C) case ∞ C Ambient Operating Temperature 0 to 70 ∞ C Storage and Junction Temperature -40 to 150 Volume CTRL DC voltage PIN CONNECTION Rth with "on board"...
Page 30
L70S Technical Service Manual ELECTRICAL CHARACTERISTICS (continued) Symbol Parameter Test Condition Min. Typ. Max. Unit µV Total Output Noise f = 20Hz to 22KHz Play, max volume µV f = 20Hz to 22KHz Play, max attenuation µV f = 20Hz to 22KHz...
Page 31
BLOCK DIAGRAM MODEL NAME : L70S 14.318Mhz Analog Scaler 17" DUAL LVDS (MST 9111) PANEL POWER & INVERTER Micro 24Mhz Controller WT61P4 AUDIO(TDA7496L) SPEAKER Image Quest Co., Ltd. Title <Title> BLOCK DIAGRAM Size Document Number <Doc> L70S Date: Monday, March 17, 2003...
Need help?
Do you have a question about the L70S and is the answer not in the manual?
Questions and answers