Nautilus MX3-200H Operating Manual page 25

NAUTILUS MX3-200H SWITCH PANEL:
(Shown with optional Pump-Out switch.)
Vacuum #1 – Power from Cord #1.
When the switch is turned to the ON
position power is supplied to the vacuum
motor. (3-Stage Vacuum)
Vacuum #2 – Power from Cord #2.
When the switch is turned to the ON position
power is supplied to the vacuum motor.
(3-Stage Vacuum)
Solution Pump Switch – Power from Cord #1.
When the switch is turned to the ON position
power is supplied to the solution pump motor.
When not using solution (Extracting only) do not
turn this switch ON.
Cooling Fan – Power from Cord #1.
The cooling fan is not controlled by any switch.
As soon as Cord #1 is plugged in the cooling
fan will turn on to exhaust air from the base.
Heater #1 –
Power from
Cord #1.
When the switch
is turned to the
ON position
power is supplied
to the first
1000W heating
element.
OPTIONAL - Waste Pump Switch
Power from Cord #2.
Switch ON unless a hose is connected to the
Pump-out Outlet port.
For pump protection there is a pressure switch
which will turn the waste pump off if the
pressure in the discharge line gets too high, as
it would if the pump was turned on while the
outlet cap was still in place.
25
Heater #2 –
Power from
Cord #2.
When the switch
is turned to the
ON position
power is supplied
to the second
1000W heating
element.
Do not turn Waste Pump