Logging In; Contact Information - Lantronix SecureLinx Quick Start Manual

S L B B r a n c h O f f i c e M a n a g e r
LOGGING IN TO THE COMMAND LINE INTERFACE
To access the command line interface
1. Do one of the following:
• With a network connection, use a Telnet or SSH program to Telnet or SSH to
xx.xx.xx.xx (the IP address in dot quad notation), and press Enter.You should be
at the login prompt. Note: By default,Telnet is disabled.To enable Telnet, use the
Services web page, a serial terminal connection, or an SSH connection.
• With a serial terminal connection, when the command line displays, press Enter.
2. Enter sysadmin as the user name and press Enter.
3. Enter PASS as the password and press Enter.The first time you log in, the Quick
Setup script opens automatically. Subsequent logins display the command prompt
only. (To obtain the Quick Setup script again, use the admin quicksetup command.)
Note: Change the default password as soon as possible to prevent access by
unauthorized personnel. Subsequent logins require the username sysadmin
and the appropriate password to log in as system administrator.
4. If the Quick Setup script displays, update basic network parameters, as desired.
Otherwise, just press Enter until the command prompt displays. By pressing Enter,
you are accepting the current settings.
Notes:
• For general command line interface help, type help command line.
• For help with a specific command, type help followed by the command, for
example, help set network or help admin firmware.
12
Q u i c k S t a r t G u i d e

CONTACT INFORMATION

For questions and technical support, please check our online knowledge base
at www.lantronix.com/support
Lantronix
15353 Barranca Parkway, Irvine, CA 92618, USA
Phone: (949) 453-3990 or Fax: (949) 453-3995
www.lantronix.com
W W W . L A N T R O N I X . C O M
13