Table of Contents
Advertisement
Section A - Installation Instructions
Warm & Serve Drawer Installation
1. Locate the 2 anti-tip brackets supplied as shown on
figure 1.
2. Slide drawer into cutout opening until front frame of
drawer is flush against cabinet. Be careful not to
pinch electrical cord.
3. Remove the drawer as instructed in the Use & Care
Guide and secure drawer housing to cabinet using
the 2 nickel-plated screws supplied (see Figure 2).
Do not overtighten screws.
4. The 60" (152 cm) appliance power cord can now be
connected into the 120 Volt outlet.
5. Proceed with mounting built-in oven above the
drawer (if applicable). Follow installation instructions
provided with built-in oven. Make sure to use anti-
tip brackets supplied with the built-in oven.
Use screws
supplied to attach
drawer to front
of cabinet.
Figure 2
5
Advertisement
Table of Contents
