Table of Contents
Advertisement
Available languages
Available languages
Quick Links
WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS
Canada
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING
flammable vapors and liquids in the vicinity of this or any other appliance.
GENERAL INFORMATION: The Warm & Serve Drawer
can be used as a stand alone appliance or combine with a
built-in oven mounted above.
NOTE: A 60" (152,4 cm) long cable is supplied with
the Warm & Serve Drawer.
Stand Alone Installation
C
B
F
D
E
Minimum distance to floor
4½" (11,4 cm)
A. HEIGHT
11 ¼" (28,6 cm)
D. CUTOUT
HEIGHT
Min.
9
/
" (25,1 cm)
28 ½" (72,4 cm)
7
8
Max.
10 ¼" (26 cm)
Printed in the USA
INSTALLATION AND SERVICE MUST BE PERFORMED
BY A QUALIFIED INSTALLER.
FOR YOUR SAFETY: Do not store or use gasoline or other
Warm & Serve Drawer Dimensions
60" (152,4 cm)
Cord
Warm and Serve
A
Drawer
Warm and Serve
Cutout
FLOOR
B. WIDTH
C. DEPTH
30" (76,2 cm)
23
3
/
" (59,4 cm)
8
E. CUTOUT
F. CUTOUT
WIDTH
DEPTH
24" (61 cm)
28 ¾" (73 cm)
IMPORTANT: The warmer drawer must be installed on
a leveled surface from left to right, rear to front and the
surface must be capable of supporting 100 lbs (45,4 Kg).
IMPORTANT: The Warm & Serve Drawer runs off a
single phase three-wire 120 volt, 60 hertz, AC only
electrical supply with ground.
Combination Warm & Serve Drawer/
Built-in Oven Installation
Caution: Two 3" (7,6 cm) wide X
3/4" (1,9 cm) thick planks have to
be install and they should be able to
support 200 pounds. (90,7 Kg)
29½"
(74.9cm)
H* = 11 5/8" (29,6cm) Min. is a Critical
dimension and has to be respected.
J** = 3" (7,6cm) Max. Electrical Junction Box for wall oven must be
lower than the warmer drawer cutout.
A. HEIGHT
11 ¼" (28,6 cm)
30" (76,2 cm)
D. CUTOUT
E. CUTOUT
HEIGHT
Min.
9
/
" (25,1 cm) 28 ½" (72,4 cm) 24" (61 cm)
7
8
Max.
10 ¼" (26 cm)
28 ¾" (73 cm)
1
United States
B. WIDTH
C. DEPTH
23
3
/
" (59,4 cm)
8
F. CUTOUT
G. HEIGHT
WIDTH
DEPTH
1 ¾" (4,4 cm)
Depends on critical
dimension H
P/N 318201810 (0901) Rev. E
English – pages 1-4
Español – páginas 5-8
Français – pages 9-12
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Electrolux 318201810
Summary of Contents for Electrolux 318201810
- Page 1 " (25,1 cm) 28 ½" (72,4 cm) 24" (61 cm) 1 ¾" (4,4 cm) 28 ¾" (73 cm) Depends on critical P/N 318201810 (0901) Rev. E English – pages 1-4 Español – páginas 5-8 Français – pages 9-12 G. HEIGHT...
-
Page 2: Important Safety Instructions
WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS Important Notes to the Installer 1. Read all instructions contained in these installation instructions before installing appliance. 2. Remove all packing material from appliance before connecting the electrical supply. 3. Observe all governing codes and ordinances. 4. -
Page 3: Model And Serial Number Location
WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS Model and Serial Number Location The serial plate is located as shown below. When ordering parts for or making inquiries about your Warm & Serve Drawer, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your Warm &... - Page 4 WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS Notes...
- Page 5 G. ALTO LA ABERTURA LA ABERTURA 24" (61 cm) 1 ¾" (4,4 cm) 28 ¾" (73 cm) Depende de la dimensión crítica H P/N 318201810 (0901) Rev. E English – pages 1-4 Español – páginas 5-8 Français – pages 9-12...
-
Page 6: Instrucciones Importantes De Seguridad
INSTRUCCIONES DE INSTALACIóN PARA EL CAjóN CALENTADOR Notas importantes para el instalador 1. Lea todas las instrucciones de instalación antes de instalar el electrodoméstico. 2. Retire todos los materiales de empaque del electrodoméstico antes de conectar la fuente de energía. 3. - Page 7 INSTRUCCIONES DE INSTALACIóN PARA EL CAjóN CALENTADOR Ubicación de la placa de serie Encontrará el número de serie y modelo impresos en la placa de serie. Cuando pida componentes o desee obtener informaciones sobre su cajón calentador, asegúrese de incluir el modelo y el número de serie o una letra o número de la placa con el número de serie de su cajón calentador.
- Page 8 INSTRUCCIONES DE INSTALACIóN PARA EL CAjóN CALENTADOR Notas...
- Page 9 F. PROFONDEUR G. HAUTEUR DÉCOUPAGE DU DÉCOUPAGE 24" (61 cm) 1 ¾" (4,4 cm) 28 ¾" (73 cm) Dépend de la dimension critique H P/N 318201810 (0901) Rev. E English – pages 1-4 Español – páginas 5-8 Français – pages 9-12...
-
Page 10: Sécurité Importantes
INSTRUCTIONS D’INSTALLATION POUR LE TIROIR-RÉCHAUD Notes importantes à l’installateur 1. Lisez toutes les instructions d’installation avant de procéder à l’installation de cet appareil. 2. Retirez tout le matériel d’emballage de l’appareil avant de brancher l’alimentation électrique. 3. Observez tous les règlements et codes locaux applicables. 4. - Page 11 INSTRUCTIONS D’INSTALLATION POUR LE TIROIR-RÉCHAUD Emplacement des numéros de modèle et de série La plaque signalétique est située tel que montré plus bas. Lors d’une commande de pièces ou pour toute demande de renseignements au sujet de votre tiroir réchaud, assurez-vous de toujours inclure les numéros de modèle et de série inscrits sur la plaque signalétique de votre appareil.
- Page 12 INSTRUCTIONS D’INSTALLATION POUR LE TIROIR-RÉCHAUD Notes...
Need help?
Do you have a question about the 318201810 and is the answer not in the manual?
Questions and answers