Table of Contents
Advertisement
7
electrolux.com.au
INSTALLATION
SAFETY
Before connecting the appliance to the mains electricity
supply make sure that the connection data on the data
plate (voltage and frequency) correspond with the mains
electricity supply, otherwise the appliance could be
damaged. Consult a qualified electrician if in any doubt.
Ensure that the power cord does not come into contact
with any hot surfaces, if necessary protect the power
cord with a barrier or insulating sleeve.
The socket and on-off switch should be easily accessible
after the appliance has been built in.
The warming drawer may only be built in combination with
those appliances quoted by Electrolux as being suitable.
Electrolux cannot guarantee trouble-free operation if the
appliance is operated in combination with appliances
other than thouse quoted by Electrolux as being suitable.
When building in the warming drawer in combination with
another suitable appliance, the food warming drawer must
be fitted above a fixed interim shelf in the housing unit.
Please ensure that the housing unit can support both its
weight and that of the other appliance.
As the combination appliance is placed directly on top
of the warming drawer once it is built in, an interim shelf
is not necessary between the two appliances.
The appliance must be built in so that the contents of the
drawer can be seen. This is to avoid scalding from hot
food spilling over. There must be enough space for the
drawer to be pulled out fully.
Use 4x appropriate screws to fix the warming drawer to
the cabinet. Open the warming drawer and screw in the
front corners.
When building in the combination appliance, it
is essential to follow the instructions given in the
operating and installation instructions supplied with
the combination appliance.
All dimensions in this instruction booklet are given in mm.
ENVIRONMENTAL PROTECTION
Unpack the appliance and dispose of the packaging
in an environmentally-responsible manner.
This appliance is labelled in accordance with the
European Directive 2012/19/EC concerning used
electrical and electronic appliances (WEEE – waste
electrical and electronic equipment). The guideline
determines the framework for the return and recycling
of used appliances as applicable.
TECHNICAL DATA
Power supply:
Total connected load:
220 -240 V
~
50/60Hz
1000 W
Advertisement
Table of Contents
