Panasonic KX-TG3531BXS Service Manual page 57

10.1.2. Check Record
BASE UNIT
A) Not record Greeting Message
B) Not record Incoming Message
C) How to change the Auto Disconnect activation (time)
Some Telephone Company lines (fiber or cable) ON Hook and OFF Hook voltages are lower than conventional lines, which may
cause a malfunction of Auto Disconnect detection. To solve this problem, try changing the Auto Disconnect activation through
the procedures below.
Auto Disconnect detect
Enable*1
Enable*1 [default]
Disable*2
Note:
*1 Both Auto Disconnect and CPC don't detect for the first 2 seconds.
*2 If the "Disable" is selected, even if the parallel-connected telephone is OFF HOOK, the line isn't disconnected.
D) How to change the VOX level
It makes easier to detect a small voice (caller) by raising the sensitivity of VOX level. Therefore, the recording of TAM is not
turned off during a detection.
VOX Level sensitivity
Normal [default]
6 dB Up
Cross Reference:
Signal Route (P.30)
Telephone Line Interface (P.16)
Auto Disconnect Circuit (P.17)
Parallel Connection Detect Circuit (P.18)
CPC detect
"STOP"+"GREETING CHECK"+"INTERCOM" simultaneously
Disable
"STOP"+"GREETING CHECK"+"VOL.
"STOP"+"GREETING CHECK"+"VOL.
"STOP"+"LOCATOR"+"VOL.
"STOP"+"LOCATOR"+"VOL.
KX-TG3531BXS/KX-TG3531BXB/KX-TG3532BXS/TG3532BXB/KX-TGA351S/KX-TGA351B
PROCEDURE at Stand-by mode
PROCEDURE
" simultaneously
" simultaneously
Note:
Flash Memory is IC601.
DSP is IC501.
57
" simultaneously
" simultaneously