Page 3
IEC power cable. Power is preset internally to operate at either 120V or 220V. CONNECTIVITY On the rear panel of the REDD.47 Mic Amplifier exists two XLR jacks, one for input, and the other for output. The XLR input is activated when the MIC/DI switch is set to ‘MIC’ or the up position.
Page 4
Overdriving the REDD.47 can be achieved in the following ways: 1. Use two REDD.47 units in series, overdriving a second unit with gain from the first unit. a. ‘Revolution’ style – via DI, plug your guitar directly into the first REDD.47, and patch the XLR out from the first unit into a second REDD.47.
Page 6
A 20db pad exists to tame hot input sources. To engage the 20db pad, flip the ‘PAD’ switch to the down position. The ‘PAD’ is handy for taming hot signals, or using the REDD.47 for in line level sources. Use a pair of REDD.47 Mic Amplifiers on your mix bus! TIP: Sending line level source material into the REDD.47 is great way to...
Page 7
Phone: (319) 885-4200 Email: support@chandlerlimited.com CE Certification Chandler Limited declares under its sole responsibility that all products manufactured by them are in compliance with Electromagnetic Compatibility (EMC) Directive 2014/30/EU; Standards: EN55103- 1:2009+A1:2012; EN55103-2:2009; EN55013:2013 and Low Voltage Directive (LVD) 2014/35/EU; Standards: EN60065:2002+A1:2006+A11:2008+A2:2010+A12:2011...
Need help?
Do you have a question about the REDD.47 and is the answer not in the manual?
Questions and answers