Page 1
Installer – Please take the time to read and understand these instructions as well as the Sunpak Installation manual P/N 65132. Copies of these instructions are available on our website or from the manufacturer. Installer must give a copy of this manual to the owner.
Page 2
POWER-UP. See Sunpak Instruction #65132 for details. POWER-UP Always start the Sunpak heater on the high setting. Once the heater is at full heat, the low setting can be used. Note: There is a 5 second delay before the heater powers up.
Page 3
2) all air has been cleared from the gas line. S34-TSH Wiring It is important that the S34-TSH heater be wired properly to get full function of the heater and to avoid damage to the unit. HI / LO Control Wiring There are three wires that control the heater.
Page 4
Thermostats are not recommended as radiant heaters warm up objects and people directly without first heating the air. QUESTIONS If you have questions regarding the proper installation or operation of the Sunpak Heater, contact your local distributor or call us at 1-888-317-5255.
Need help?
Do you have a question about the S34-TSH and is the answer not in the manual?
Questions and answers