Sunpak S34-TSH Installation, Operation And Maintenance Instructions

Sunpak S34-TSH Installation, Operation And Maintenance Instructions

Gas-fired high-intensity infrared heater

Advertisement

Quick Links

Installer: Please take the time to read and understand these instructions prior to installation. Installer
must provide a copy of this manual to the owner.
Owner: Keep this manual in a safe place in order to provide your service technician with the
necessary information.
Warning:
These instructions are intended for qualified personnel, specifically trained and experienced in the
installation and repair of this type of equipment and related system components.
WARNING: California
Proposition 65
IF NOT INSTALLED, OPERATED AND MAINTAINED IN
ACCORDANCE WITH THE MANUFACTURER'S
INSTRUCTIONS, THIS PRODUCT CAN EXPOSE YOU TO
SUBSTANCES IN THE FUEL OR FROM COMBUSTION
INCLUDING CARBON MONOXIDE RESULTING IN DEATH
OR SERIOUS ILLNESS AND WHICH ARE KNOWN TO THE
STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH
DEFECTS OR REPRODUCTIVE HARM.
information go to
www.P65WARNINGS.CA.GOV
Form No 32048 – 11/20
Gas-fired high-intensity infrared heater
Installation, Operation and & Maintenance Instructions
For more
Infrared Dynamics, Inc © Copyright 2020
Sunpak S34-TSH
For indoor or outdoor installation.
NOT FOR USE IN RESIDENTIAL DWELLINGS
NOTE: Heater above shown with optional Face Trim
Warning
Improper installation, adjustment, alteration,
service or maintenance can cause death, injury
or property damage. Read and understand the
installation, operating and maintenance
instructions thoroughly before installing or
servicing this heater.
Infrared Dynamics, Inc
3830 Prospect Avenue
Yorba Linda, CA 92886
http:\\sunpak.us - (888) 317-5255
Printed in USA

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S34-TSH and is the answer not in the manual?

Questions and answers

Summary of Contents for Sunpak S34-TSH

  • Page 1 For more DEFECTS OR REPRODUCTIVE HARM. information go to www.P65WARNINGS.CA.GOV Infrared Dynamics, Inc 3830 Prospect Avenue Yorba Linda, CA 92886 http:\\sunpak.us - (888) 317-5255 Form No 32048 – 11/20 Infrared Dynamics, Inc © Copyright 2020 Printed in USA...
  • Page 2: High Altitude Installations

    Sunpak® S34-TSH Infrared Heaters Sunpak Table of Contents heaters work like the sun projecting Warnings radiant heat down to warm your patio and guests. This heater was designed for outdoor 2. Basic Operation installation; however, breezes will affect the 3. Heater Layout and Design heating efficiency, and severe weather 4.
  • Page 3: Basic Heater Operation

    NOTE: Sunpak Heater shown with optional Face Trim The Sunpak S34-TSH should always be started up and operated on the High mode for the first 5 minutes to allow ® the heater to warm up. Starting up the heater on the LOW mode before the heater is warmed up may cause the heater to shut down prematurely.
  • Page 4 MINIMUM CLEARANCE FROM COMBUSTIBLE MUST BE MAINTAINED (see chart on page 6 & 7 ANGLE MOUNTING: Most applications of the SUNPAK will raise the comfort level 5-10º Fahrenheit outdoors. The above coverage table was based on still breeze conditions. Sunpak® heater may be angle-mounted to a Under windy conditions more heat will be required.
  • Page 5 Sunpak® S34-TSH Infrared Heaters...
  • Page 6 Sunpak® S34-TSH Infrared Heaters Warning: Heater must be level in the lengthwise direction.
  • Page 7: Installation Instructions

    Sunpak® Infrared Heaters Installation/Service Instructions Gas Supply The gas inlet supply pressure and manifold pressures required Receiving Equipment for each heater are listed below. For gas supply line pressures in excess of ½ PSI, consult with your gas service provider or the On receipt of equipment it is suggested that a visual inspection be made for external damage to the carton.
  • Page 8 Electrical Heaters subject to vibration shall be provided with 1. Sunpak S34-TSH Heaters need 24 VAC to operate. vibration isolating hangers. A special lighted switch is provided which also Suitable materials for hanging infrared heaters are steel requires 24 VAC.
  • Page 9: Fire Sprinklers

    Fire Sprinkler Systems near heaters. Initial Start- Up Procedure (Read entire Procedure First) Sunpak Pilot and Electrode Position 1. Before turning ON your new heater make sure: a. Heater is securely mounted and clearances from combustible materials have been observed (see ____________________________________ Clearances –...
  • Page 10 Optional Face Trim can be easily installed on all Sunpak models You must remove the Sunpak Face Trim to connect power to the heater. The Sunpak Face Trim is secured with four (4) screws, two (2) located along each side of the heater.
  • Page 11 Sunpak® Infrared Heaters...
  • Page 12 Sunpak® Infrared Heaters...
  • Page 13 Sunpak® Infrared Heaters...
  • Page 14 Control System – Page 11 • Secure ground wire to heater body inside control compartment • Adjust pilot electrodes 3/16 from pilot hood. Sunpak Pilot – Page 9 Pilot Electrode Replace TSH Control Module • Control Components – Page 11 •...
  • Page 15: Limited Warranty

    Sunpak® Infrared Heaters Limited Warranty THIS WARRANTY IS APPLICABLE TO THE ORIGINAL OWNER ONLY, in accordance with the warranty terms and conditions specified below. Infrared Dynamics (the warrantor) will furnish at our option the ORIGINAL OWNER, 1) a replacement Infrared Dynamics’ heater or 2) a replacement part for any component part which fails before one year when for residential use.

Table of Contents