Toshiba RAS-B10SKVP-E Service Manual page 102

12-3. Outdoor Unit
No. Part name
Common 1. Detachment
1
procedure
Wear gloves for this job.
Otherwise, you may injure your hands on
the parts, etc.
1) Stop operation of the air conditioner, and
2) Remove the valve cover.
3) Remove wiring cover (ST1TØ4 × 8L
4) Remove the upper cabinet.
2. Attachment
1) Attach the water-proof cover.
The water-proof cover must be attached
without fail in order to prevent rain water,
etc. from entering inside the indoor unit.
2) Attach the upper cabinet.
3) Perform cabling of connecting cable, and
4) Attach the valve cover.
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Procedure
NOTE
turn off the main switch of the breaker for
air conditioner.
(ST1TØ4 × 8L 1 pc.)
• After removing screw, remove the valve
cover pulling it downward.
2 pcs.), and then remove connecting cable.
(ST1TØ4 × 8L 2 pcs.)
• After removing screws, remove the upper
cabinet pulling it upward.
NOTE
(ST1TØ4 × 8L 2 pcs.)
• Hook the rear side of the upper cabinet to
claw of the rear cabinet, and then put it on
the front cabinet.
attach the wiring cover.
(ST1TØ4 × 8L 2 pcs.)
• Place the wiring cover over the opening
used to work on the connecting wires of
the rear cabinet, and secure it using the
two fixing screws (ST1TØ4 × 8L 2 pcs.).
At this point, the top cushion of the wiring
cover must be on the inside of the open-
ing.
(ST1TØ4 × 8L 1 pc.)
• Insert the upper part into the square hole
of the rear cabinet, set hook claws of the
valve cover to square holes (at three
positions) of the main unit, and attach it
pushing upward.
– 102 –
www.heronhill.co.uk
Remarks
Upper cabinet
Water-proof
cover
Wiring cover
Valve cover
Upper cabinet
Fax: 01823 665807