Epson Stylus CX4100 Service Manual page 38

EPSON Stylus CX4100/CX4200/CX4700/CX4800/DX4200/DX4800/DX4850
1.5.3.1 Rules for Scanning Index Sheets
Index sheet scan range
Set index sheet in scanner
• Place the side to be scanned face down relative to the scan bed, as described
below.
Align the corner of the sheet to the upper left origin point and make sure the
sheet is straight. Angled setting of the sheet is allowed as long as the sheet
remains within the scan bed's scan range (the maximum angle on the scan
bed is about 2.8°).
• The cover must be closed on the original to enable scanning. (This is to
prevent any shifting of the position marks while scanning).
• Do not use paper that allows images to "bleed through" to the rear side.
(This is to prevent empty bubbles from being filled in by "bleed-through".)
Set scan area and original
Table 1-37. Set Scan Area and Original
RW OLM
(readable width) (out-of-range left margin)
216 mm (8.5") 1.5 mm ± 1 mm
Place the Index Sheet face down with its top edge aligned to the left edge of
the scan bed, and with the corner of the paper set to the original's top left
position.
PRODUCT DESCRIPTION
RL OTM
(readable length) (out-of-range top margin)
297 mm (11.7") 1.5 mm ± 1 mm
Memory Card Print (Only for CX4700/CX4800/DX4800/DX4850)
Original's top left alignment position
First pixel
Scan direction
OLM
RW
OTM
RL
Operator's side
Figure 1-14. Set Scan Area and Original
Revision A
Set original face down,
with top aligned in the
direction of the origin.
Scan bed
Scan area
38