Johnson SKEE-HORSE 25-201R Service Manual page 86

11-2
CENTER PUNCH
Figure 11-1
LOCK NUT
DESCRIPTION
This section gives complete service instructions on the snowmobile
steering, track, and suspension.
STEERING
DISASSEMBLY
a. Support front end of snowmobile to remove weight from skis.
IMPORTANT
Mark ski column and steering arm with center punch as shown
in Figure 11-1. Marking is required to assure correct steering
geometry on reassembly.
b. Remove ski and leaf spring assembly. Disassemble leaf spring,
if
required, for servicing.
c. Remove steering arm from ski column. See Figure 11-2.
d. Remove ski columns.
CLEANING, INSPECTION, AND REPAIR
a. Remove all dirt and old grease from ski columns and from inside
ski column brackets.
b. Inspect steering column bushing and replace
if
worn. See Figure
11 - 2.
c. Inspect ski column upper and lower rubber mounts and bushing for
wear, damage, or deterioration.
d. Inspect ski runners and replace if worn.
e. Inspect leaf springs for cracks or weakness.
WE AR PLATE
""""- RETAINING PIN
17502
Figure 11-2
)
•