Johnson SKEE-HORSE 25-201R Service Manual page 73

•
(
f. Reconnect neutral lockout cable to bracket and actuating arm.
See Figure 9-5.
g. Install belt guard.
h. Reconnect red lead to electric starter motor. Install starter belt.
Adjust tension as described in Section 7.
i. Install spark plugs and connect leads.
j. Reconnect cable harness to air baffle.
k. Install fuel inlet and return lines to carburetor and pulse and
primer lines to intake manifold on crankcase.
l. Reinstall instrument panel to chassis. Feed primer assembly
forward under carburetor and install to chassiS. See page 6-7
for adjustment procedure.
m. Secure instrument panel to chassis with three screws in rear of
panel and one on either side at the instrument panel to chassis
bracket.
n. Reinstall steering column. First replace three bolts in lower
flange. Torque to specifications. Install rubber bushing and yoke.
See Figure 9-7.
o. Reconnect speedometer and tachometer cables, engine, ignition/
light switch, and cigarette lighter connectors.
p. Reconnect compression relief cable to compression relief valve.
See page 5-5 for adjustment procedure.
q. Screw shift handle back onto reverse operating rod.
r. Reconnect fuel lines to bottom of primer and to fuel pump.
s. Reinstall brake caliper to secondary. Brake cable adjustment
should not have been disturbed. See Section 10 if adjustment is
required .
t. Reconnect fuel gauge cable and replace cap.
u. Reconnect throttle and choke cables to carburetor. See Section 6
for cable adjusting procedure.
v. Reinstall manual starter assembly to engine. Remove knot in
rope and feed rope through opening in instrument panel. Feed
through hole
in
grip and tie knot.
9-11