Speakers Set - Yamaha RX-V540 Service Manual

RX-V540/RX-V540RDS/HTR-5650/HTR-5650RDS/DSP-AX540
RX-V440/RX-V440RDS/HTR-5640/HTR-5640RDS/DSP-AX440

4. SPEAKERS SET

The input signal is automatically identified and switched in
the priority order of dts → DOLBY DIGITAL → AAC →
PCM AUDIO → Analog (A/D) according to the signal
detection.
The signals output from the DSP block are the same as 1.
DSP THROUGH: YSS 0dB.
MAIN: SMALL 0dB
Front Mix: 5ch
Tone Control +10dB
The analog switch settings for each sub-menu are as
shown in the table below.
Sub-menu
1 MAIN: SMALL 0dB
2 CENTER: NONE
3 LFE/BASS: MAIN
4 FRONT MIX: 5CH
5 REAR CENTER: POWER
LARGE: This mode is used with a speaker with high
bass reproduction performance (a large
unit). Full bandwidth signals are output.
SMALL: This mode is used with a speaker with low
bass reproduction performance (a small
unit). The signals of 90Hz or less are mixed
into the channel specified by LFE/BASS.
NONE: This mode is used with no center speaker.
The center content is reduced by 3dB and
distributed to MAIN L/R.
Sub-menu
6 Tone Control Flat
7 Tone Control +10dB
8 Tone Control –10dB
32
Rear Center power
Tone Control –10dB
CENTER SP REAR SP MAIN SP MAIN LEVEL LFE/BASS
LARGE LARGE SMALL
NONE LARGE LARGE
SMALL SMALL LARGE
LARGE LARGE LARGE
LARGE LARGE LARGE
Treble Bass
0 dB 0 dB
+10 dB +10 dB
–10 dB –10 dB
LFE/BASS: MAIN
Tone Control Flat
0dB SWFR
0dB BOTH
0dB MAIN
0dB BOTH
0dB BOTH