Set Speed On The Ethernet Port; Set Cable Type For The Ethernet Port - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - Port
Quidway S3000-EI Series Ethernet Switches
The Gigabit electrical Ethernet port can operate in full duplex, half duplex or
auto-negotiation mode. When the port operates at 1000Mbps, the duplex mode can be
set to full (full duplex) or auto (auto-negotiation).
The port defaults the auto (auto-negotiation) mode.

1.3.2 Set Speed on the Ethernet Port

You can use the following command to set the speed on the Ethernet port. If the speed
is set to auto-negotiation mode, the local and peer ports will automatically negotiate
about the port speed.
Perform the following configuration in Ethernet port view.
Table 1-5 Set speed on Ethernet port
Set 100M Ethernet port speed
Set Gigabit Ethernet port speed
Restore the default speed on Ethernet port
Note that, the 100M electrical Ethernet port can operate at 10Mbps, 100Mbps or
auto-negotiated speed as per different requirements.
100M optical Ethernet port supports 100Mbps and can be configured to operate at 100
(100Mbps) or auto (auto-negotiation).
The optical Gigabit Ethernet port supports the 1000Mbps speed and the speed can be
set to 1000 (1000Mbps) or auto (auto-negotiation).
The electrical Gigabit Ethernet port can operate at 10Mbps, 100Mbps, or 1000Mbps as
per different requirements. However in half duplex mode, the port cannot operate at
1000Mbps.
By default, the speed of the port is in auto mode.

1.3.3 Set Cable Type for the Ethernet Port

The Ethernet port supports the straight-through and cross-over network cables. The
following command can be used for configuring the cable type.
Perform the following configuration in Ethernet port view.
Operation
Huawei Technologies Proprietary
1-4
Chapter 1 Ethernet Port Configuration
Command
speed { 10 | 100 | auto }
speed { 10 | 100 | 1000 | auto }
undo speed