Panasonic Viera TH-P42GT20Z Operating Instructions Manual page 82

FAQs
Due to the digital reception technologies involved, quality of the Digital TV signals may be
relatively low in some cases, despite good reception of Analogue TV channels.
Unable to receive signals
with a high-performance
aerial
Interference or
frozen / disappearing
image in Digital TV
Cannot see 3D images
3D Eyewear is turned off
automatically
There is something wrong
with the 3D images
TV goes into Standby
mode
The remote control does
not work or is intermittent
Parts of the TV become hot
82
Problem
●
Install an aerial individually for the TV and VCR
(or use a splitter).
TV
Aerial
Input
terminal
VCR
●
Check "Digital TV Signal Condition" (p. 38).
If "Signal Quality" is displayed in red, check aerial. If problem
persists, consult your local Panasonic dealer.
●
Turn the TV off with the Mains power On / Off switch, then
turn it On again.
●
Has the 3D Eyewear been switched On?
●
Ensure that "3D Picture Display" in "3D Settings" is set to
"3D". (p. 27)
●
Some 3D image signals may not be automatically recognized
as 3D images. Set "3D Picture Format" in "3D Settings" to
match the picture format. (p. 27)
●
Check that there are no obstacles between the infrared
sensors on the TV and the 3D Eyewear. If the 3D Eyewear
stops receiving the infrared signal for about 5 minutes, the 3D
Eyewear will be turned off automatically.
●
Check the available area to use the 3D Eyewear. (p. 25)
●
Depending on the person, the 3D images may be difficult
to see, or cannot be seen, especially in users that have a
different level of eyesight between the left and right eyes.
Take the necessary steps (wearing glasses etc.) to correct
your eyesight before use.
●
Check that there are no obstacles between the infrared
sensors on the TV and the 3D Eyewear or that the 3D
Eyewear is placed inside the coverage area (p. 25). If the
3D Eyewear stops receiving the infrared signal for about
5 minutes, the 3D Eyewear will be turned off automatically.
●
Check the setting of "3D Picture Sequence" or "Edge
Smoother". (p. 27)
●
Auto power standby function is activated.
●
The TV enters Standby mode about 30 mins. after analogue
broadcasting ends.
●
Are the batteries installed correctly? (p. 3)
●
Has the TV been switched On?
●
Point the remote control directly at the front of the TV (within
about 7 m and a 30 degree angle of the front of the TV).
●
Situate the TV away from sunshine or other sources of bright
light not to shine on the TV's remote control signal receiver.
●
Even when the temperature of parts of the front, top and rear
panels has risen, these temperature rises will not pose any
problems in terms of performance or quality.
Actions
(Individual aerial)
Splitter
Aerial Output
Aerial Input
Aerial Output
(Individual aerial)