Card Slot Attribute; Memory Card Direct Printing Function - Canon S530D Service Manual

6.4 Card slot attribute

The card slot attributes can be changed by operating the Memory Card Startup Utility on the host computer.
Card Slot Attribute
Read only
Read/Write
Note:
When the memory card is inserted to the printer, this attribute cannot be changed.
As the card slot attributes are stored in nonvolatile memory on the printer, attributes are kept even if the
printer is powered off by disconnecting the AC plug.

6.5 Memory Card Direct Printing Function

6.5.1. Print mode
"Print Selected" mode: To produce a blank frame
Once the applicable frame is set, set the next frame, and then change the applicable frame to "----".
Ex. In a four-frame layout, to produce a blank frame in the second cell.
[Procedures on the operation panel in the Print Selected mode]
Order:
Specified photo number:
6.5.2. Print Quality
The following quality levels can be selected. (O: Selectable)
Photo Paper Pro 4"X6"
Photo Paper Plus 4"X6"
Photo Paper Pro Perforated 4"X6"
Photo Paper Pro Letter
Photo Paper Pro A4
Plain Paper Letter
Plain Paper A4
Default setting is Quality 2.
To protect the data on the memory card, writing to the memory card inserted in
the card slot is prohibited. (Default setting)
Writing data to the memory card inserted in the card slot is allowed. (Use of
memory cards where the write protection is set to the Read Only mode is
prohibited.)
-01- -02-
0001 0002
0001
0003
State
-03- -02- -04-
0003 ---- 0004
0004
Quality1 Quality2
-
-
-
-
-
Quality3
-
-
16