Pioneer XC-P01-S Operating Instructions Manual page 14

General control
Muting
The volume is muted temporarily when pressing the MUTE
button on the remote control. Press again to restore the
volume.
DIRECT function
Press the DIRECT button on the remote control or on the
stereo receiver to listen to the sound source in the original
sound quality. The DIRECT indicator lights in the front panel
display of the stereo receiver when the DIRECT function is on.
Press the DIRECT button again to cancel the DIRECT
function.
Note
• If the DIRECT function is turned off when the volume is
set to 61 or higher, the volume is automatically set to 60.
Bass control
Press the BASS + button on the remote control to emphasize
the bass, and the BASS – button to de-emphasize it.
Note
• This function is not available when the DIRECT function is
on.
Treble control
Press the TREBLE + button on the remote control to emphasize
the treble, and the TREBLE – button to de-emphasize it.
Note
• This function is not available when the DIRECT function is
on.
Input selection
The input source for the stereo receiver can be selected by
pressing the INPUT button repeatedly or each input selection
button (CD/USB, TUNER, NETWORK, and DIG IN 1/2) on the
remote control, or turning the SOURCE knob on the stereo
receiver.
14
En
Note
• If pressing the INPUT button on the remote control
repeatedly or turning the SOURCE knob on the stereo
receiver to the right, the input source is switched in the
following order.
CD/USB TUNER NETWORK
DIGITAL IN 2 DIGITAL IN 1
If turning the SOURCE knob to the left, the order is reversed.
• The backup function will memorize the input mode and
restore it in case of a power failure or that the AC power
cord is disconnected.
Headphones
Plug headphones (commercially available) into the PHONES
socket on the stereo receiver.
• Do not turn the volume on to full at switch on and listen
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing loss.
• Before plugging in or unplugging the headphone, reduce
the volume.
• Be sure your headphone has a 3.5 mm diameter plug and
impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
• Plugging in the headphone disconnects the speakers
automatically.
Auto power down setup
The unit turns off automatically if no operations are
performed for specified period of time.
• Default setting: 6H
1 Select the stereo receiver or CD player by pressing the
CONTROL RCV or CONTROL CD button on the remote
control.
2 Press the SETUP button.
3 Press / to specify the amount of time.
You can select 0.5 (CD player only), 2, 4 or 6 hours, or off (if
no automatic shutoff is desired).
4 Press the ENTER button.
Note
• Press the RETURN button to exit the setting mode without
setting the auto power down function.
CAUTION
• If setting the auto power down for the stereo receiver,
both of the stereo receiver and CD player are
automatically turned off after the specified period of time
has elapsed.
If setting the auto power down for the CD player, only the
CD player is automatically turned off after the specified
period of time has elapsed.