Lincoln Electric LN-8 SVM132-A Service Manual page 87

F-37
WIRE DRIVE ASSEMBLY AND COMPONENT REPLACEMENT
FIGURE F.12 – REED SWITCH REMOVAL AND SHUNT ELECTRICAL CONNECTIONS
REED
SWITCH
BRACKET
#568
#567
7. Disconnect two leads #567 (blue),
and lead #568 (blue) from the
shunt using the 11/32 in. wrench.
See Figure F.12. Note the lead
placement on the shunt for
reassembly.
8. Using a 7/16 in. wrench, loosen
the two hex head screws that
secure the reed switch bracket to
TROUBLESHOOTING AND REPAIR
HEX HEAD
SCREWS
SHUNT
the front of the wire drive assem-
bly. Slide the bracket off the front
of the wire drive assembly.
9. Using an offset flat blade screw-
driver, remove the two mounting
screws below the shunt and the
one mounting screw below the
wire drive motor. Remove the wire
drive assembly through the wire
drive side of the case.
LN-8
F-37
(continued)