E-3
Observe all Safety Guidelines detailed throughout this manual
PRObLEMS
(SYMPTOMS)
PRObLEMS IN TIG WELDING
Oxidation
Tungsten inclusions
Porosity
Hot cracking
TROUbLESHOOTING
POSSIbLE
CAUSE
1. lnsufficient gas.
2. No protection on the back side.
1. lncorrect electrode sharpening.
2. Electrode too small.
3. Operating failure (contact of the
tip with the workpiece).
1. Dirt on the edges.
2. Dirt on the filler material.
3. Excessive travel speed.
4. Current intensity too low.
1 Unsuitable filler material.
2. High heat supply.
3. Dirty materials.
V160-T
RECOMMENDED
COURSE OF ACTION
If all recommended possible areas of
misadjustment have been checked
and the problem persists, Contact
your local Lincoln Authorized
Field Service Facility.
E-3