Serial Ports (Com1 ~4) - Lead International FPC-7500 User Manual

1.8.2 Serial Ports (COM1 ~4)

Both FPC-7500 and FPC-7502 are built with an integrated serial ports that
combines COM1 ~ COM4 into a D-sub 44-pin female connector. Each port
supports RS-232; in addition, COM4 supports RS-232/422/485 selectable.
To connect to any serial device, follow the steps below:
1. Turn off the BOX PC system and the serial devices.
2. Attach the interface cable of the serial device to the serial connector.
Be sure to fasten the retaining screws.
3. Turn on the computer and the attached serial devices.
4. Refer to the serial device's manual for instructions to configure the operation
environment to recognize the new attached devices.
5. If the serial device needs specified IRQ or address, you may need to run
the CMOS setup to change the hardware device setup.
FPC-7500
FPC-7502
Ant.
Optional
+ -
SW
DC IN
10V~28V
Ant.
Optional
+ -
COM1~COM4
SW
DC IN
10V~28V
- 10 -
General Information
DisplayPort
DisplayPort