Tyre Pressure Monitoring (Tpms) - Volvo V60 Owner's Manual

Hide thumbs Also See for V60:
Table of Contents

Advertisement

General
TPMS (Tyre Pressure Monitoring System)*
warns the driver when the pressure is too low
in one or more of the car's tyres. It uses sensors
located inside the air valve in each wheel.
When the car is driven at about 40 km/h the
system detects the tyre pressure. If the pres-
sure is too low then a warning lamp
instrument panel illuminates and a message is
shown on the display.
Always check the system after changing a
wheel in order to ensure that replacement
wheels work with the system.
For information on correct tyre pressures, see
page 355.
The system does not replace normal tyre main-
tenance.
IMPORTANT
If a fault should arise in the tyre pressure
system a warning lamp
on the instru-
ment panel will illuminate and a message
will be shown. This can be for various rea-
sons, e.g. fitting a wheel not equipped with
a sensor adapted for Volvo's tyre pressure
monitoring system.
Adjusting tyre pressure monitoring
Tyre pressure monitoring can be adjusted in
order to follow Volvo's tyre pressure recom-
mendations, when driving with a heavy load for
example.
NOTE
on the
The engine must not be running when the
tyres are calibrated.
The settings are made with the control in the
centre console, see page 142.
1. Inflate the tyres to the required pressure
and select key position I or II.
2. Select the menu system MY CAR to open
the menus to
Settings
3. Select
Calibrate tyre pressure
4. Press OK.
5. Start the car and drive at least at 40 km/h
for a total of at least 1 minute and check
that the message disappears.
> Calibration is complete.
Rectifying low tyre pressure
If a message for low tyre pressure is shown in
the display:
1. Check the tyre pressure in all four tyres.
07 Wheels and tyres

Tyre pressure monitoring (TPMS)*

2. Inflate the tyre(s) to the correct pressure.
3. Drive at least at 40 km/h for a total of at
least 1 minute and check that the message
disappears.
Deactivating/activating tyre pressure
monitoring
NOTE
The engine must not be running when tyre
pressure monitoring is activated/deacti-
vated.
The settings are made with the control in the
centre console, see page 142.
1. Select key position I or II.
Tyre pressure
2. Select the system MY CAR to open the
.
menus to
3. Select
OK.
> A
X
is activated, the option disappears if the
system is deactivated.
Recommendations
Only factory fitted wheels are equipped with
TPMS sensors in the valves.
If wheels without TPMS sensors are used
Tyre press. syst Service required
then
*
Option/accessory, for more information, see Introduction.
Car settings
Tyre pressure
Tyre pressure system
and press
is shown in the display if the system
07
``
297

Advertisement

Table of Contents
loading

Table of Contents