Removing The Indoor Fan Motor And The Line Flow Fan - Mitsubishi Electric Mr.Slim MSZ09UN Service Manual

OPERATING PROCEDURE
3. Removing the electrical box
(1) Remove the front panel. (Refer to 1.)
(2) Remove the electrical cover.
(3) Remove the connector of the indoor coil thermistor (CN112).
(4) Remove the motor connector and the vane motor connector
(CN151) on the electronic control P.C. board.
(5) Remove the screw of the electrical box, remove the
electrical box.
4. Removing the vane motor
(1) Remove the front panel. (Refer to 1.)
(2) Remove the electrical box. (Refer to 3.)
(3) Pull out the drain hose from the nozzle assembly, remove
the nozzle assembly.
(4) Remove the screws (both upper and lower) of the vane
motor, disconnect the connector.
(5) Remove the vane motor.

5. Removing the indoor fan motor and the line flow fan

(1) Remove the front panel. (Refer to 1.)
(2) Remove the electrical box.
(3) Unhook the catch on the both sides of the nozzle
assembly.
(4) Remove the nozzle assembly.
(5) Remove the screws of the bearing support.
(6) Remove the screw of the heat exchanger and unhook the
catch.
(7) Lifting the heat exchanger, remove the bearing support.
(8) Loose the screw fixing the line flow fan, remove the
line flow fan.
(9) Remove the screws of the motor band, remove the fan
motor.
Photo 3
Vane motor
Photo 4
Catch
Screw of the
heat exchanger
Screws of the
bearing support
Photo 5
Line flow fan
65
PHOTOS
Screws of
the vane
motor
Screw of the
electrical cover
Heat exchanger
Indoor fan motor
Screw of the
motor band
Screws
of the
motor
band