Advertisement
NYSW
1. Align all 3 hands at 12 o'clock
The watch does not run and the LCD display is blank after a new battery is replaced until the following initia-
tion has been done.
Now turn the watch to set the hands and initialize the electronic
All hands (hour, minute and second hands) have to be moved to the 12 0'clock position (12:00:00) for initializ-
ing.
1. Press and holding S1 (the right top button), you'll see the second-hand starts fast running.
2. You can stop the high speed running second-hand by a press of S1
3. To restart the fast running second-hand, press and hold S1 again
4. When the fast running second-hand is driving hour and minute hands closing to the 11:59:00, stop the
second-hand with one press of S1. Continuously pressing S1 one press a time until all hands align at 12:00:00
(if you accidentally go past the 12, start the above proceedure again.)
5. When all hands are aligned at the 12 0'clock position (12:00:00), PUSH S4 (the left lower button) hardly
for 1 second to confirm.
6. After confirmation, the LCD display is switched ON and shows a blinking City Name
2. Now Set your Time Zone (through City Name)
1. After the LCD shows a city name, press S1 (the upper right button) or S2 (the lower right button) to set your
Time Zone through City Name (please refer to "Table of Time Zone against City Name")
2. Press S4 once to confirm
3. After confirmation, the watch will initiate a signal reception automatically. Put the watch nearby a window to
get signal.
4. The watch will run to the right time if the reception is successful or starts to run at around 12 o'clock if the
reception is failed.
3. Put the watch to a location (window) where reception is possible for 24 to 48 hours to
allow the watch to receive radio signal to set the correct time.
Signal is always good in nighttime but not in daytime.
So, if the initial daytime reception is failed, put the watch to a location (window) where reception is possible for
24 to 48 hours to allow the watch to receive radio signal to set the correct time. The watch will automatically
initiate a reception at 3AM after receiving a valid time signal, the hands move on to the correct time.
For technical support, please feel free to call 1-800-399-1629,
or visit our website: www.newyorkstandardwatch.com
New York Standard Watch Company
Instruction Manual
SOHO Series - P103A-01, P103A-02, P201-07, P201-08
(3 hands Analog-Digital Atomic Watch)
.
www.NewYorkStandardWatch.com
2007 EN
Page 8
Advertisement
