Casio UP-360 Service Manual page 5

1-3-4. DRAWER KICK-OUT CONNECTOR
The pulse specified by ESC p or DLE DC4 is output to this connector. The HOST can confirm the status
of the input signal by using the DLE EOT, GS a, or GS r commands.
PIN I/O
1 - Frame ground
2 Output Drawer kick-out drive signal 1
3 Input Drawer open/close signal
4 Output +24 V
5 Output Drawer kick-out signal 2 *
6 - Signal ground
* Two drawers can be used with a Y-cable that meets the following specifications.
Pin 1: Frame ground ............................................................ Pin1
Pin 2: Drawer kick-out drive signal 1 ................................... Pin2
Pin 3: Drawer open/close signal .......................................... Pin3
Pin 4: +24V .......................................................................... Pin4
Pin 5: Drawer kick-out signal 2 ....................
Pin 6: Signal ground Pin6 .............
CONNECTIOR MODEL:
Printer side: MOLEX52065-6615 or equivalent
Used side:
DESCIPTION
......... Pin6
............................. Pin1
........................ Pin2
................... Pin3
.............. Pin4
....................................... Pin6
6-position 6-contact (RJ12 telephone jack)
— 3 —
Connector of Drawer No.1
Connector of Drawer No.2