Advertisement
I
I
13. (For Special area only)
If the supply
cord of this appliance
replaced
by a repair shop appointed
special purpose tool are required.
CARE AND MAINTENANCE
is
by
damaged,
it must
the manufacturer,
only be
because
When you have trouble with the unit, inspect it according to the points in
the
"Trouble-Shooting
Guide"
If
inspection
indicates
a malfunction,
refrain
from using the unit to avoid damage, and see your dealer or the
nearest Sanyo Service Centre.
Trouble-Shooting
Guide
Symptom
Items to inspect
The dust indicator
Is the filter dirty?
moves immediately
to
the orange zone
Clean the filter.
Suction does not get
stronger after cleaning
IS
the floor
nozzle,
turbin
brush or the
hose clogged with a large object?
out the dirt (Weak
suction)
Push it out with a garden hose.
Motor does not run
Is the cord damaged where it is connected
continuously
(Motor
to the plug, or are you pulling on the cord
starts and stops)
too hard or bending it.
Change the cord.
The cord does not go
Is the cord twisted
or wound uneven on
back fully into the
the roller?
unit
Pull the cord out 1-2m and try rewinding
it again.
Motor does not run
Is the hose inserted into the unit properly?
when turned ON.
Check the connection
of the hose and
the unit.
Turbine brush does
.
See whether there is waste paper, a match
not rotate. (SC T9200/
stick,
or the
like
stuck
in the turbine
T9200EM/T9200EMK)
brush.
Remove any foreign substance.
Advertisement
